Width of 62462 and 3062b should be equal but isn't


Width of 62462 and 3062b should be equal but isn't
#1
Dear Philippe Hurbain [Philo], 

In real life these two pieces are a good fit:
[Image: 200x267.jpg]

but studio renders them like this [sorry image updated with version that is rendered with the updated version of the piece, so reference removed]



hpoort at studio forum - explained Wrote:It looks as though the outer cylinder of the connector is too small (18 LDU in stead of the 19 LDU of the round brick).

Note that neither of these numbers represent the exact size of the parts, as that would be 20 LDU minus tolerances. The tolerances used in LDraw are not the exact tolerances used by LEGO in producing these parts, but are integer approximation best suited for digital building.



Can this be fixed?
Let me know if you need more photo's, renders or files.

Thank you very much.
[color=gray]My LEGO MOC's with PDF building instructions and stop-motion animations can be found on https://rebrickable.com/users/BrickDesignerNL/mocs/[/color]
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Width of 62462 and 3062b should be equal but isn't - by van der Harg - 2021-02-13, 18:30

Forum Jump:


Users browsing this thread: 1 Guest(s)