Curved Patterned Part/Sticker Question

[Roland Melkert]

My question pertains to patterned parts/stickers. Once you add pattern to the curved part, even if the original curvature of the sticker could have been represented with a primitive the new, color specific elements simply cannot.

I'm not a part author, but rendering wise these kind of parts are known to cause normal interpolation problems.

This because the surface of triangles does not match the same portion of the part's curve.

I think you could prevent it by adding extra triangles so the pattern 'rests' on a evenly curved grid.

Or it might be better to use textures for non flat stickers.