Chain around gears in LDCad

RE: Chain around gears in LDCad
(2020-12-04, 12:31)Philippe Hurbain Wrote: I made a short video showing how to create the loop around your three gears:

Yellow rectangle show the keys and mouse clicks used.
Shortcuts used:
"O" to put the origin on an existing part
"shift+C" to move selected element to the origin.
...and the trick to be on the correct side of gear: select the control point, right click, change winding from CW to CCW.
Note that I slightly goofed in my video, I put the origin in the middle of pin instead of gear, so the chain was out of plane, and I had to correct that...

I don't see the point of your other example, why don't you use a single chain element?
« Next Oldest | Next Newest »

Messages In This Thread
RE: Chain around gears in LDCad - by NikosSprocket - 2020-12-04, 16:59

Forum Jump:

Users browsing this thread: 1 Guest(s)