Philo has already drawn a lot of pneumatic tubes for use in the PLI of LPub3D and uploaded them to the PartsTracker.
For a MOC I need some that are not yet available. For example 11L and 12L.
Since these are relatively simple, I would like to submit them later.
Now to my question: According to which scheme are the tubes named?
I don't see any connection.
For a MOC I need some that are not yet available. For example 11L and 12L.
Since these are relatively simple, I would like to submit them later.
Now to my question: According to which scheme are the tubes named?
I don't see any connection.
If nothing goes right, go left.