LDCad—Tying the knot


RE: LDCad—Tying the knot
#5
(2019-11-14, 17:26)Philippe Hurbain Wrote: It would also be possible to create a knot part, but I'm not sure it would be better/easier to use...

How brave! I generally go with only 1 layer of string... But yes, Bezier is the right CP to use, circle don't work well in this case (where is the wire supposed to leave one circle to go to another? what path in between?)

Well, at least I didn't attempt to tie the knot under the string, where it attaches to the spool!  Wink

So is there an application where it does make sense to mix circle and bezier points? 'Cos that's exactly the problem I had: how to get the string to follow the correct path in and out of the circle.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
LDCad—Tying the knot - by N. W. Perry - 2019-11-13, 0:57
RE: LDCad—Tying the knot - by N. W. Perry - 2019-11-14, 15:33
RE: LDCad—Tying the knot - by N. W. Perry - 2019-11-14, 19:13
RE: LDCad—Tying the knot - by N. W. Perry - 2019-11-15, 6:30
RE: LDCad—Tying the knot - by N. W. Perry - 2019-11-15, 23:19
RE: LDCad—Tying the knot - by N. W. Perry - 2019-11-18, 4:42
RE: LDCad—Tying the knot - by N. W. Perry - 2019-11-23, 1:36

Forum Jump:


Users browsing this thread: pete, 1 Guest(s)