Pattern Projection on a surface
2019-05-15, 10:03 (This post was last modified: 2019-05-15, 10:04 by Vincent Messenet.)
2019-05-15, 10:03 (This post was last modified: 2019-05-15, 10:04 by Vincent Messenet.)
I try to project a pattern on a surface using SlicerPro within LD Part Editor but I can't figure out how it works while it seems to me I follow the instructions.
In attachment to this thread you will find my file and I try to project the plan pattern on the red squares. So I select the whole pattern in a view, then I control click on a view set on Top, I open the tool SlicerPro and click on OK then a progress bar appear which goes quickly and nothing appear.
Could you please let me know what I am doing wrong?
Thanks!
11477pz1.dat (Size: 5.11 KB / Downloads: 3)
In attachment to this thread you will find my file and I try to project the plan pattern on the red squares. So I select the whole pattern in a view, then I control click on a view set on Top, I open the tool SlicerPro and click on OK then a progress bar appear which goes quickly and nothing appear.
Could you please let me know what I am doing wrong?
Thanks!
11477pz1.dat (Size: 5.11 KB / Downloads: 3)