LDCad Rubber band generation


RE: LDCad Rubber band generation
#3
That is most certainly possible. I assume you already know how to work with LDCad templates.
You need three control points: 1 for each big wheel each and 1 at the bush in the center.
Then, select the center control point and open the properties (clicking on the little XYZ popup). Then change the Direction from 'Clockwise on XY' to 'Counter Clockwise on XY' and it should do the trick. Or, at least it did for me...
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: LDCad Rubber band generation - by Merlijn Wissink - 2018-12-06, 16:37
RE: LDCad Rubber band generation - by Shi.Yan - 2018-12-13, 10:18

Forum Jump:


Users browsing this thread: 1 Guest(s)
Forum Jump:


Users browsing this thread: 1 Guest(s)