LDCad Flex part>Motor cable not editable?


RE: LDCad Flex part>Motor cable not editable?
#2
(2018-05-10, 11:52)Jetro de Château Wrote: I haven't made any models in a while and I ran into an issue guiding the cable of an M-Motor. At first I thought I was out of practice, but then I noticed the cable on the sensor I used looked different: none of my motor parts have editing points in the cable.

I have recently updated to LDCad 1.6b, but I am not aware of having made any changes. 
How can I get the editing points back?
Hi Jetro,
No significant change either in program or templates... I guess that by "editing points" you don't mean the local stiffness adjustment balls as we see them on your screenshots. Just remember that you can use the "dynhp" mode to make cable transparent to access the balls if they are hidden.
Otherwise, to add a new control point, select either the motor or the connector and hit "Ins" key.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: LDCad Flex part>Motor cable not editable? - by Philippe Hurbain - 2018-05-10, 15:15

Forum Jump:


Users browsing this thread: 2 Guest(s)