Wrapping tepee cover


RE: Wrapping tepee cover
#11
Using a small drill bit... Support holes are now there, remains the entrance hole.
Big problem: the flat and formed files are now a soup of tri/quads, and I have no idea how to sort both files in the same order to generate a LPC template. LPC template which is usable only if precision issue is fixed anyway...

If LPC is fixed, the best bet is probably to make a template from undrilled files, and drill again the patterned version. If it is not, then the best solution is probably to make pattern from side projections (4 sides) and repair pattern at junctions with LDPE. Drawback of the last method, no flat version is generated as a by-product.

   


Attached Files
.dat   tepee-holes.dat (Size: 215.14 KB / Downloads: 2)
.dat   tepee-holes-flat.dat (Size: 139.59 KB / Downloads: 1)
.ldr   tepee.ldr (Size: 830 bytes / Downloads: 2)
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Wrapping tepee cover - by Willy Tschager - 2016-11-11, 19:15
RE: Wrapping tepee cover - by Willy Tschager - 2016-11-11, 20:28
RE: Wrapping tepee cover - by Magnus Forsberg - 2016-11-12, 13:30
RE: Wrapping tepee cover - by Willy Tschager - 2016-11-12, 20:12
RE: Wrapping tepee cover - by Willy Tschager - 2016-11-14, 12:01
RE: Wrapping tepee cover - by Philippe Hurbain - 2016-11-14, 16:16
RE: Wrapping tepee cover - by Magnus Forsberg - 2016-11-14, 17:50
RE: Wrapping tepee cover - by Willy Tschager - 2016-11-14, 19:23
RE: Wrapping tepee cover - by Magnus Forsberg - 2016-11-15, 16:38
RE: Wrapping tepee cover - by Willy Tschager - 2016-11-14, 19:30
RE: Wrapping tepee cover - by Orion Pobursky - 2016-11-16, 18:33
RE: Wrapping tepee cover - by Willy Tschager - 2016-11-14, 19:34

Forum Jump:


Users browsing this thread: 1 Guest(s)