Conditional lines on part cylinders


Conditional lines on part cylinders
#1
Why do the part cylinders (n-fcyli.dat) have a conditional line at their edge? One control point lies inside the part but the second one lies outside. In a lot of cases that outside one will be wrong. When it is you have to add another conditional line with the correct control points but that means you have two lines in the same position.
I guess this is one of those things that are now impossible to fix because of the sheer number of parts you'd have to update.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Conditional lines on part cylinders - by Ronald Vallenduuk - 2013-10-17, 6:58

Forum Jump:


Users browsing this thread: 3 Guest(s)