Strange (buggy?) behaviour in LDView BFC system
2013-07-23, 5:16 (This post was last modified: 2013-07-23, 23:28 by Tim Gould.)
2013-07-23, 5:16 (This post was last modified: 2013-07-23, 23:28 by Tim Gould.)
Hi Travis,
I discovered today (after much tearing out of hair) that BFC red+green does not work when lighting is turned off[1]. Basically, the part is returned to its default colour if you switch off lighting, regardless of what is set in the BFC options.
It seems to me that these two options should not be related like that, and that BFC should work regardless. Not sure if this is a bug, or just a quirk, but it would probably be nice to see either a decoupling, or a warning.
Tim
[1] In 4.1 and 4.2b1
I discovered today (after much tearing out of hair) that BFC red+green does not work when lighting is turned off[1]. Basically, the part is returned to its default colour if you switch off lighting, regardless of what is set in the BFC options.
It seems to me that these two options should not be related like that, and that BFC should work regardless. Not sure if this is a bug, or just a quirk, but it would probably be nice to see either a decoupling, or a warning.
Tim
[1] In 4.1 and 4.2b1