whitespace deals.. 0//
2013-03-15, 20:34 (This post was last modified: 2013-03-15, 21:16 by Santeri Piippo.)
2013-03-15, 20:34 (This post was last modified: 2013-03-15, 21:16 by Santeri Piippo.)
So I was working on my little parts authoring tool (ldforge) again and ran into a little problemo: is there required to be a whitespace after the numeric code for comments? Is a line like "0// edge lines" valid or are they considered errorneous?
I would assume it's illegal but assuming is bad, so yeah. The specification doesn't seem to mention anything about this, maybe I am blind as usual?
I would assume it's illegal but assuming is bad, so yeah. The specification doesn't seem to mention anything about this, maybe I am blind as usual?