LDraw.org Discussion Forums › Models and Parts › Parts Authoring v
Question about edges

Question about edges


Travis Cobbs Offline
LDraw.org Moderator ******
App Developers James Jessiman Memorial PTSubmit Standards Board
Posts: 1,873
Threads: 84
Joined: Jul 2011
Re: Question about edges
#17
2013-03-11, 18:20
The Numeric Precision and Format section of the File Format Restrictions for the Official Library specifies that parts and non-scalable primitives are not allowed to use more than 3 decimal places, and scalable primitives aren't allowed to use more than 4 decimal places. It's worth noting, however, that just because that level or precision is allowed, it doesn't mean that relying on it will work.
Website Find
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Question about edges - by Roland Melkert - 2013-03-08, 20:41
Re: Question about edges - by Roland Melkert - 2013-03-09, 19:11
Re: Question about edges - by Roland Melkert - 2013-03-09, 20:23
Re: Question about edges - by Ben Supnik - 2013-03-10, 4:18
Re: Question about edges - by Roland Melkert - 2013-03-10, 18:35
Re: Question about edges - by Ben Supnik - 2013-03-10, 23:11
Re: Question about edges - by Roland Melkert - 2013-03-10, 23:32
Re: Question about edges - by Ben Supnik - 2013-03-11, 2:31
Re: Question about edges - by Travis Cobbs - 2013-03-11, 5:19
Re: Question about edges - by Ben Supnik - 2013-03-11, 6:20
Re: Question about edges - by Tim Gould - 2013-03-11, 6:40
Re: Question about edges - by Ben Supnik - 2013-03-11, 18:52
Re: Question about edges - by Roland Melkert - 2013-03-11, 20:31
Re: Question about edges - by Tim Gould - 2013-03-11, 20:58
Re: Question about edges - by Roland Melkert - 2013-03-11, 23:48
Re: Question about edges - by Tim Gould - 2013-03-11, 23:57
Re: Question about edges - by Tim Gould - 2013-03-12, 1:24
Re: Question about edges - by Travis Cobbs - 2013-03-12, 5:12
Re: Question about edges - by Tim Gould - 2013-03-11, 21:07
Re: Question about edges - by Ben Supnik - 2013-03-22, 22:33
Re: Question about edges - by Tim Gould - 2013-03-22, 22:44
Re: Question about edges - by Ben Supnik - 2013-03-22, 23:48
Re: Question about edges - by Travis Cobbs - 2013-03-11, 18:20
Re: Question about edges - by Roland Melkert - 2013-03-11, 20:50
Re: Question about edges - by Roland Melkert - 2013-03-12, 18:15
Re: Question about edges - by Ben Supnik - 2013-03-12, 18:24
Re: Question about edges - by Roland Melkert - 2013-03-12, 18:37
Re: Question about edges - by Travis Cobbs - 2013-03-10, 6:57

Forum Jump:


Users browsing this thread: 18 Guest(s)