LDraw.org Discussion Forums › Models and Parts › Parts Authoring v
Question on faces

Question on faces


Nicola Offline
Seasoned LDrawer ***
Posts: 125
Threads: 23
Joined: Nov 2012
Question on faces
#1
2012-11-22, 19:42 (This post was last modified: 2012-11-26, 19:17 by Nicola.)
Hi, i have a question: are faces considered double sided in parts that are not "BFC certified"?
For example i'm rendering part 6595 and it renders wrong, it's not certified as far as i can see.
Find
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Question on faces - by Nicola - 2012-11-22, 19:42
Re: Question on faces - by Steffen - 2012-11-22, 20:23
Re: Question on faces - by Philippe Hurbain - 2012-11-23, 10:17
Re: Question on faces - by Steffen - 2012-11-23, 18:50
Re: Question on faces - by Travis Cobbs - 2012-11-25, 2:49
Re: Question on faces - by Nicola - 2012-11-26, 14:16
Re: Question on faces - by Nicola - 2012-11-26, 15:00
Re: Question on faces - by Philippe Hurbain - 2012-11-26, 16:13
Re: Question on faces - by Nicola - 2012-11-26, 16:19
Re: Question on faces - by Magnus Forsberg - 2012-11-26, 17:28
Re: Question on faces - by Nicola - 2012-11-26, 19:17

Forum Jump:


Users browsing this thread: 2 Guest(s)