Possible error in mlcad.ini v2011-01?
2011-08-26, 0:04 (This post was last modified: 2011-08-26, 17:03 by Willy Tschager.)
2011-08-26, 0:04 (This post was last modified: 2011-08-26, 17:03 by Willy Tschager.)
I think the xyz translation of [LHand]:"Hand Hook" and [RHand]:"Hand Hook" should be "0 0 0.4" instead of "0 0.4 0".
But I could be wrong...
Try adding this (before deleting the official "Hand Hook" lines!), I think it's better(?)
"TE Hook" "2531.DAT" 0 1 0 0 0 1 0 0 0 1 0 0 0.4
/Tore
But I could be wrong...
Try adding this (before deleting the official "Hand Hook" lines!), I think it's better(?)
"TE Hook" "2531.DAT" 0 1 0 0 0 1 0 0 0 1 0 0 0.4
/Tore