> You mean that the blade in LUT part is too small compared to the real part?
It seems to be. After comparing the three wheels (LUT, mine, real one) overa nd over again I came to the conclusion that the LUT part has the outer shell a bit too thick, which causes the big gap on the outer edge. Not sure about the inner one.. gonna have to check that one.
Didn't think of that resizing method, though... thanks!
It seems to be. After comparing the three wheels (LUT, mine, real one) overa nd over again I came to the conclusion that the LUT part has the outer shell a bit too thick, which causes the big gap on the outer edge. Not sure about the inner one.. gonna have to check that one.
Didn't think of that resizing method, though... thanks!