OMR specs

[Willy Tschager]

Currently I am working on an app that uses much the OMR Spec.

So I need to fully understand it.

I have a problem with the following content:

Code:

Each individual model file in the MPD that represents an unofficial part must use the standard header format of unofficial parts on the parts tracker. Its 0 FILE entry will reflect the modified MPD version of the part's filename, but the rest of the header will reflect the original filename.

So far i remember is the 0 FILE entry the in the MPD file the file name for the code that follows until next 0 FILE entry or...

In the above it is stated that the 0 FILE entry contains the modified file name and the rest should be like the original DAT-file. If I strictly follow that I would have a 0 FILE entry that is different from the 0 Name entry.

According to the MPD Spec those both entries should be the same!

I am currently confused !

Please help me.

To be honest I cannot see the problem. Since we change the filename to:

<Set Number>[-<Optional Qualifier>] - <Unofficial Part Number>.dat

there has to be set an exceptional rule for the rest of the header. You cannot for example change the <Author Name>
or the <Individual filename>. Find below the unofficial part I included in the Green Grocer. I think it represents a valid example:

0 FILE 10185 - 60616.dat
0 Glass for Door 1 x 4 x 6
0 Name: 10185 - 60616.dat
0 Author: Santeri Piippo [arezey]
0 !LDRAW_ORG Unofficial_Part
0 !LICENSE Redistributable under CCAL version 2.0 : see CAreadme.txt

0 !HELP To place the glass on 30179.dat, have it -32LDU on the X-axis
0 !HELP relative to the door to place it correctly.

w.