LDraw.org Discussion Forums › General › Parts Tracker Discussion v
LDraw.org Official Parts Library Standards: Introduction

LDraw.org Official Parts Library Standards: Introduction


Orion Pobursky Offline
Administrator
Administrators App Developers James Jessiman Memorial LDraw Member PTAdmin PTSubmit Standards Board Steering Committee
Posts: 5,238
Threads: 740
Joined: Jul 2011
RE: LDraw.org Official Parts Library Standards: Introduction
#3
4 hours ago
(4 hours ago)Roland Melkert Wrote: Found this a bit confusing, so 0.123,  00000.123  and .123 are all allowed?

The first and third are ok, the second is not. This is already enforced by the PT submit validation.

Follow up: Should the PT autocorrect these errors and issue a warning instead?

Good feedback.
Find
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: LDraw.org Official Parts Library Standards: Introduction - by Orion Pobursky - 4 hours ago

Forum Jump:


Users browsing this thread: 5 Guest(s)