Oops, I searched for train threads but it didn't pull anything up. 😅 Should I delete this thread and post in that other one?
To be honest, I have no idea.
I'm not sure how to have it neatly not be--snapping tools in LeoCAD weren't all that helpful and I couldn't for the life of me find the track layout editor I saw mentioned when I searched.
Ha, funny you mention this--I originally did two and then was worried it would be a technically incorrect part manifest since, if I remember right, the two were connected by one wire. But I am new to this. 😬
I can swap out these parts and upload the revised version. Going to try my hand at the on-track placement a little longer. Thanks for the response!
Quote:*"0 NOFILE" what caused this?
To be honest, I have no idea.
Quote:*Is it intentional that the train is "off rails"?
I'm not sure how to have it neatly not be--snapping tools in LeoCAD weren't all that helpful and I couldn't for the life of me find the track layout editor I saw mentioned when I searched.
Quote:*connector cable (the wedge thing) should be dark grey, also if you want to include it, 2 might be better
Ha, funny you mention this--I originally did two and then was worried it would be a technically incorrect part manifest since, if I remember right, the two were connected by one wire. But I am new to this. 😬
I can swap out these parts and upload the revised version. Going to try my hand at the on-track placement a little longer. Thanks for the response!