I would like you to remove the duplicated surface inside the bottom stud
1 16 10 -16 -10 0 0 1 0 10.5 0 1 0 0 axlehole.dat
1 16 10 -13.5 -10 0 0 1 0 -3.35 0 -1 0 0 stud4.dat
The top studs can't be in the subfile. Need to be at top level to avoid mirroring of the logo.
Cutting flat surface that go across the cutting plane is not good. Like these:
4 16 -10 0 -10 -10 0 6.25 -6.36 0 6.25 -6.36 0 -10
4 16 -10 0 6.25 -10 0 -10 -10 -16 -10 -10 -16 6.183
4 16 26.25 -7.18 -10 26.25 -7.18 -8.75 26.25 0 6.25 26.25 0 -10
.. and more.
1 16 10 -16 -10 0 0 1 0 10.5 0 1 0 0 axlehole.dat
1 16 10 -13.5 -10 0 0 1 0 -3.35 0 -1 0 0 stud4.dat
The top studs can't be in the subfile. Need to be at top level to avoid mirroring of the logo.
Cutting flat surface that go across the cutting plane is not good. Like these:
4 16 -10 0 -10 -10 0 6.25 -6.36 0 6.25 -6.36 0 -10
4 16 -10 0 6.25 -10 0 -10 -10 -16 -10 -10 -16 6.183
4 16 26.25 -7.18 -10 26.25 -7.18 -8.75 26.25 0 6.25 26.25 0 -10
.. and more.