(2026-02-22, 7:29)Roland Melkert Wrote: It renders whenever something related changes. eg an editing change or hot tracking in the same (partbin/colorbin/edit/source) region.
There are some things you can check:
- be sure the frame render method is fbo (prefs/Opengl)
- lower the cell count of the partbin (-/+)
- try disabling hottracking in partbins (prefs/gui)
The framerate is fine as long as I don't open the "File Content"/"All Models" in the Parts Bin.
My assumption is that this drives down the frame rate due to the generation of the preview imagesas you move parts around, as this might impact mere sub-models, a lot of the preview images are rendered
My question is more towards the direction if the rendering of the preview-images can be reduced, e.g.:
- only once a part has been placed, or e.g. a second after a part has been placed.
- only after you press "end" of "Ctrl-End", i.e. render them only once.
Form smaller models the current state is no issue at all, as a few hundred parts are fine.