I had an intermittent issue with LDCad where i experienced an incredible drop in the frame rate, down to 1 fps from a 20 fps rendering.
This is with a file of 25.000 parts, many of them technic beams. I first thohought that the increased accuracy of the npegholes contributed to this effect, but now I found the real reason.
I use a number fo subfiles in this MPD and whenever I switch to the MPD view, because I need a file or want to select one and I stayed there, the framerate was very sluggish.
switching back ti a "normal" parts bin e.g.used parts or "brick"increased the frame rate massively.
Are you rendering the content of the small tiles inthe MPD view kind of real time? would there be a way to avoid this behaviour?
thansk
Gerald
This is with a file of 25.000 parts, many of them technic beams. I first thohought that the increased accuracy of the npegholes contributed to this effect, but now I found the real reason.
I use a number fo subfiles in this MPD and whenever I switch to the MPD view, because I need a file or want to select one and I stayed there, the framerate was very sluggish.
switching back ti a "normal" parts bin e.g.used parts or "brick"increased the frame rate massively.
Are you rendering the content of the small tiles inthe MPD view kind of real time? would there be a way to avoid this behaviour?
thansk
Gerald