RE: 6536 problem converting dat to obj/stl
Yesterday, 0:17 (This post was last modified: Yesterday, 0:17 by Chris Böhnke.)
Yesterday, 0:17 (This post was last modified: Yesterday, 0:17 by Chris Böhnke.)
Hello,
export .dat as .stl via LDView (File -> Export) typically works (I also tested for 6536).
There are a few converters for stl -> obj out there, or just use Blender.
Is this a problem related to general file conversion or specific to your script?
Where does the issue occur exactly?
export .dat as .stl via LDView (File -> Export) typically works (I also tested for 6536).
There are a few converters for stl -> obj out there, or just use Blender.
Is this a problem related to general file conversion or specific to your script?
Where does the issue occur exactly?