Mainly this primitive would be used in parts where the top of the stud goes into the part so the edge lines that would be drawn in the primitive would not show up.
LDraw.org Discussion Forums
›
Models and Parts
›
Parts Authoring
Is there any demand for a stud4s with no edge lines?
Is there any demand for a stud4s with no edge lines?
Is there any demand for a stud4s with no edge lines?
« Next Oldest | Next Newest »
| Messages In This Thread |
|
Is there any demand for a stud4s with no edge lines? - by Mark Kennedy - Yesterday, 3:31
RE: Is there any demand for a stud4s with no edge lines? - by Gerald Lasser - Yesterday, 7:45
RE: Is there any demand for a stud4s with no edge lines? - by Mark Kennedy - Yesterday, 10:02
|
Users browsing this thread: 1 Guest(s)