Hello,
For example, part 15068 consists of a lower section 15068s1. The upper section consists of part of a cylinder 1-8cyli.
Both parts contain the optional lines. For each part with a pattern, the optional lines for the upper section must be added.
My suggestion would be to use a primitive 1-8cyli without optional lines and move the optional lines to the lower part.
This would mean that they would not have to be added to every part with a pattern.
I compared several parts and the optional lines were almost always the same, with most deviations due to rounding (e.g. 4 <-> 3.9999).
The colour of the pattern also has no effect, as the colour was always 24.
My question is, what are the arguments against my suggestion?
Regards
Manfred
For example, part 15068 consists of a lower section 15068s1. The upper section consists of part of a cylinder 1-8cyli.
Both parts contain the optional lines. For each part with a pattern, the optional lines for the upper section must be added.
My suggestion would be to use a primitive 1-8cyli without optional lines and move the optional lines to the lower part.
This would mean that they would not have to be added to every part with a pattern.
I compared several parts and the optional lines were almost always the same, with most deviations due to rounding (e.g. 4 <-> 3.9999).
The colour of the pattern also has no effect, as the colour was always 24.
My question is, what are the arguments against my suggestion?
Regards
Manfred