Backslash is required. Forwardslash is not allowed. It may or may not be clear from the documentation, but you will get an error if uploading to the parts tracker.
LDraw.org Discussion Forums
›
Models and Parts
›
Parts Authoring
Filepath Backslash(\) or Forwardslash(/)
Filepath Backslash(\) or Forwardslash(/)
Filepath Backslash(\) or Forwardslash(/)
« Next Oldest | Next Newest »
| Messages In This Thread |
|
Filepath Backslash(\) or Forwardslash(/) - by Hageta - 2025-08-18, 15:16
RE: Filepath Backslash(\) or Forwardslash(/) - by Hageta - 2025-08-18, 16:08
RE: Filepath Backslash(\) or Forwardslash(/) - by Travis Cobbs - 2025-08-18, 16:42
RE: Filepath Backslash(\) or Forwardslash(/) - by Peter Blomberg - Yesterday, 0:14
RE: Filepath Backslash(\) or Forwardslash(/) - by Orion Pobursky - Yesterday, 3:07
RE: Filepath Backslash(\) or Forwardslash(/) - by Hageta - Yesterday, 11:42
RE: Filepath Backslash(\) or Forwardslash(/) - by Orion Pobursky - Yesterday, 11:53
|
Users browsing this thread: 2 Guest(s)