LPub: Part Lengths
2012-08-02, 19:19 (This post was last modified: 2013-05-08, 13:07 by Gerald Lasser.)
2012-08-02, 19:19 (This post was last modified: 2013-05-08, 13:07 by Gerald Lasser.)
What discriminator does LPub use to determine the lengths of parts? Some parts such as Technic beams and axles will display a length in the Parts List. However, other parts such as Technic bricks and 1/2 width beams do not. Is there any way for me to edit the part files to enable this, or is it hard coded into LPub? I do a lot of Technic instructions and it is often quite difficult to tell from a PLI whether a 14L or 16L brick is used, for example.