Anyone have any Modulex parts?
I'm working on a set of parts made by Chris Dee and Tore Eriksson.
The zip-file contained the slopes, but are they correct?
In this image from the marketing documents they seem to be of the same height. Both the front ends and the backsides are all the same height.
modslope.png (Size: 105.42 KB / Downloads: 63)
But if I look at the parts made for ldraw they are of different height. And there is not enough space inside the 45 deg slope for a stud.
The angle of the different slopes seem to be correct; 9, 18, 27 and 45 degrees
I'm working on a set of parts made by Chris Dee and Tore Eriksson.
The zip-file contained the slopes, but are they correct?
In this image from the marketing documents they seem to be of the same height. Both the front ends and the backsides are all the same height.
modslope.png (Size: 105.42 KB / Downloads: 63)
But if I look at the parts made for ldraw they are of different height. And there is not enough space inside the 45 deg slope for a stud.
The angle of the different slopes seem to be correct; 9, 18, 27 and 45 degrees