LDraw.org Discussion Forums › Off Topic › Off-Topic v
3D print LEGO element

3D print LEGO element


Nate87 Offline
LDraw User **
Posts: 6
Threads: 0
Joined: May 2025
RE: 3D print LEGO element
#18
2025-05-27, 9:03
(2025-05-26, 22:27)Hageta Wrote: Make sure to set the quality settings to high, to get smoth curves.
I mentioned all the relevant settings at the end of this reddit post:
https://www.reddit.com/r/bioniclelego/co..._printing/
Also do not forget to set the units to milemeters(mm).

On my way over to have a look.  Thanks again.
Find
Reply
« Next Oldest | Next Newest »



Messages In This Thread
3D print LEGO element - by Jaco van der Molen - 2025-02-07, 13:08
RE: 3D print LEGO element - by Jeff Jones - 2025-02-07, 14:00
RE: 3D print LEGO element - by Nate87 - 2025-05-26, 8:59
RE: 3D print LEGO element - by Nate87 - 2025-05-26, 9:05
RE: 3D print LEGO element - by Hageta - 2025-05-26, 22:27
RE: 3D print LEGO element - by Nate87 - 2025-05-27, 9:03
RE: 3D print LEGO element - by Jose Alfonso - 2025-02-07, 17:16
RE: 3D print LEGO element - by Orion Pobursky - 2025-02-07, 17:53
RE: 3D print LEGO element - by Chris Böhnke - 2025-02-07, 23:31
RE: 3D print LEGO element - by Jose Alfonso - 2025-02-08, 9:28
RE: 3D print LEGO element - by Jeff Jones - 2025-02-08, 13:26
RE: 3D print LEGO element - by Johann Eisner - 2025-03-07, 13:20

Forum Jump:


Users browsing this thread: 1 Guest(s)