Make Part 45590 Flexible

[Philippe Hurbain]

Here's a proposal to make this rubber part from flexible k0x parts

In the new Slave-1 this part is used to attach the side panels to the structure, streching the part a bit, respectively taking advantage of the flexibility.

All parts are in the ZIP

45590_v2 is the standard one

45590_Test as it is used on the Slave-1

While doing so, I added the slight curve on the part

Tough one, I'm afraid I don't master enough LDCad templates making
Here's what I've done so far, but I'd like to hear Roland on this question!

Otherwise, I think the segments should contain a "skirt" going inside the part to allow overlaps between segments and mask the junctions