Hello Gabriel, nice explanation...
I also fiddled around a bit with these connections, and found out that all connections have some kind of ID number...
Do you have a list which number is what and what connection fits what counterpiece?
For example: Stud fits antistud and center of big hollow antistud...
Positive hollow stud too, but additionally has clip connectivity (for bar)
Bar is similar to thin bottom stud...
Some conns like the technic hole have options (start/end capped), how does that show?
Some conns have defined IDs, the pair is always one number apart:
-technic pinhole 2, technic pin 3
-technic axlehole 6, technic axle 7 (axle with stop has 9)
-round hole 10, bar for round hole 11
-clip 12, bar 13
René
I also fiddled around a bit with these connections, and found out that all connections have some kind of ID number...
Do you have a list which number is what and what connection fits what counterpiece?
For example: Stud fits antistud and center of big hollow antistud...
Positive hollow stud too, but additionally has clip connectivity (for bar)
Bar is similar to thin bottom stud...
Some conns like the technic hole have options (start/end capped), how does that show?
Some conns have defined IDs, the pair is always one number apart:
-technic pinhole 2, technic pin 3
-technic axlehole 6, technic axle 7 (axle with stop has 9)
-round hole 10, bar for round hole 11
-clip 12, bar 13
René