RE: 12V Transformers
2024-11-16, 3:15 (This post was last modified: 2024-11-16, 3:16 by Chris Böhnke.)
2024-11-16, 3:15 (This post was last modified: 2024-11-16, 3:16 by Chris Böhnke.)
I am not entirely sure about this, but shouldn't there be at least 2 transformers (12V and 9V) for each plug type? So the plugs would be used at least twice. Is there a sort of consensus on how many parts are needed to justify a new prim? I had a similar unsolved issue a while back with the Basic/Freestyle eye (https://library.ldraw.org/parts/39408).
Personally I think having the cable modelled would be nice.
But as far as I understand it "preformed" cables are not added to the library anyway, so leaving the cable segments for LSynth is maybe more consistent at the moment?
Some or all (?) of those transfomers also came with a special milky white plastic clamp to hold it coiled together. So either this configuration or one of those seen in instructions photos might be appropriate?
On another note, the existing models of train transformers don't have the info sticker on them. Should that be added as well?
Personally I think having the cable modelled would be nice.
But as far as I understand it "preformed" cables are not added to the library anyway, so leaving the cable segments for LSynth is maybe more consistent at the moment?
Some or all (?) of those transfomers also came with a special milky white plastic clamp to hold it coiled together. So either this configuration or one of those seen in instructions photos might be appropriate?
On another note, the existing models of train transformers don't have the info sticker on them. Should that be added as well?