Another little nitpick would be the y-coordinate of the neck connector:
I would assume that this is meant to be 'in system', meaning the y-value should be exactly 24 LDU not 24.006 LDU.
This would apply to the entire flat 'neck' area. Did you measure this value yourself?
Unfortunatley I can not access one of mine to compare at the moment
I would assume that this is meant to be 'in system', meaning the y-value should be exactly 24 LDU not 24.006 LDU.
This would apply to the entire flat 'neck' area. Did you measure this value yourself?
Unfortunatley I can not access one of mine to compare at the moment