LDCad 1.1 Beta 1 (win+linux)

[Jason Smith]

ctrl+p starts resizing the pin length without having to click it's end first.

Ah, thank you so much.

After modeling the submodel you switch back to the higher model (click on the filename at the right top for all open models).

In that model you can then place the submodel like any other part by using the special 'overview/file content' part bin group (half build dozer picture / doc with 'mpd' icon.)

Hope this is somewhat clear, I have to do a tutorial at some point.

It's very clear thanks again. The whole overview part bin group totally escaped me. In the middle of building a sub file right now, can't wait to try it.