Value of colours in LDconfig.ldr

[Eugen]

you're comparing 2 different parts in 2 different photos taken under very different lighting conditions.

And in all of the light conditions both parts materials looks differently. There are much more photos of this engine and its always the same: propeller (even in its taller hub part) always is a half transparent white, where the nose (even in its thin stiffeners part) is always opeaque white.
So, I'm 99.9% sure that nose and propeller are made of different materials: one from Polypropylene, and another from Nylon.

• https://www.findtop.com/the-best-uv-resi...ene-nylon/
  

Anyway, talking about LDconfig.ldr and colours in LDraw: I just tried the same parts (see attached LDR file, bricks on plate are placed for reference).

Test MPD-file: 
  MabuchiS1-colour-test.ldr (Size: 485 bytes / Downloads: 4)


Issues:

In LeoCAD (same for LPub3D as well) there are next issues appearing (parts colours IDs in round brackets are assigned manually, parts colors IDs in angle brackets are hardcoded in shortcuts):

1. Shortcut parts has Black edges for all the parts linked — if assemble it manually from, edges for each part are shown correctly per each part colour;
   
2. In a shortcut with main colour assigned to any transparent colour there is "full transparent Propeller part" glitch (there no such for the "Front" aka nose part) — there is no such glitch in a shortcut with main colour assigned to opaque colour, and if assemble all the parts manually and set transparent colour for "" part
   
3. Pin part of the "Front" (nose) part is visible throw "Base" part if view it from the front — there is no such glitch if view from the rear/back.
   

(I will adress LeoCAD issues to its developer, but it would be good if the sample LDR file would be tested in other software, including in LDraw official software too)

   

In LDView (and probably the same for Parts Tracker's render, which based on headless LDview build) there is only "Issue 3" applicable

   

In LDCad there only one issue: shortcut has has extra transparency in Nose/Base connection zone

       

In Online LDraw Model Viewer:

• https://forums.ldraw.org/thread-24106-po...l#pid55331