Ok, here is my attempt to understand this.
There are two sets of switches. One older 4110, with a recessed socket for the pin on the left side,
and one newer 4707 with a more flat design.
First question: Is it correct that the two families contain only four switches each?
Quote:
Remote Control with Decoupler Pattern exist only in old version
Remote Control with 2 Circled Arrows Pattern exist only in new version
Or do we make 2 sets of 5 switches?
Second question:
We also have new information about the correct part numbers on the switches.
u9001 is 4709
u9002 is 4708
These files are official and need to have Move to-files made.
Is it possiblle to use the Move to routine here? 9001 and 9002 have a different (incorrect?) rotation point.
(I'm assuming Javier wants to have new versions made, or already have them ready?)
The real question is: Can we use the Move to-routine here, or do we need to make them obsolete?
Lets start with these questions. I think they will be decisive of how we should move on.
I have many more.
There are two sets of switches. One older 4110, with a recessed socket for the pin on the left side,
and one newer 4707 with a more flat design.
First question: Is it correct that the two families contain only four switches each?
Quote:
Remote Control with Decoupler Pattern exist only in old version
Remote Control with 2 Circled Arrows Pattern exist only in new version
Or do we make 2 sets of 5 switches?
Second question:
We also have new information about the correct part numbers on the switches.
u9001 is 4709
u9002 is 4708
These files are official and need to have Move to-files made.
Is it possiblle to use the Move to routine here? 9001 and 9002 have a different (incorrect?) rotation point.
(I'm assuming Javier wants to have new versions made, or already have them ready?)
The real question is: Can we use the Move to-routine here, or do we need to make them obsolete?
Lets start with these questions. I think they will be decisive of how we should move on.
I have many more.