encoding some Technic tubing


RE: encoding some Technic tubing
#5
just tried it with some parts i had at hand: the 73590 hose (8,5L) is too long (bends outwards)...
but the technic hoses can be inserted into that halfpin and the cones, so you can vary there.
Maybe even put a long one through the center?

Edit: found a longer one and tested it again: about 8L (fully inserted both sides), but a longer one (about 14-16L) going through would also be ok
-> test it in real life and then place the part digitally
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: encoding some Technic tubing - by Rene Rechthaler - 2024-10-01, 20:48

Forum Jump:


Users browsing this thread: 1 Guest(s)