(2024-07-03, 13:04)Jaco van der Molen Wrote: It seems impossible to put a 85611 Plate 1x2 round with Open stud under a 20482 Tile 1x1 Round with Pin and Pin hole.
(2024-07-03, 13:41)Jaco van der Molen Wrote: Another thing that is very hard is if you have stacked a normal plate, a 1x1 round plate and another normal plate on top and then if you put another plate on that, the last plate always
Both are caused by the same problem as before.
The current engine needs improving when matching a short cylinder shape to a long one.
The 2ldu thing is because of the slide property of the pin.
The short-term solution is to put a normal anti stud snap meta to the problem parts. It is redundant but it ensures the shorter one 'wins' the matching games.
But it might also ruin the whole point of the longer cyl meta as those are suppose to allow non stud use of the part.