Another thing that is very hard is if you have stacked a normal plate, a 1x1 round plate and another normal plate on top and then if you put another plate on that, the last plate always seems to prefer snapping 2 LDU above the stud of the 1x1 round plate?
As a consequence you again have to be very accurate to move the last plate a bit up to snap it to the normal plate, on the round plate.
This is mostly the case if other studs are near.
Try building this
![[Image: AP1GczMbFQIVaFxhbdaMvWm53I8q_y6FhVIIXhoO...authuser=0]](https://lh3.googleusercontent.com/pw/AP1GczMbFQIVaFxhbdaMvWm53I8q_y6FhVIIXhoOEYOr6R6za9m8MKjttA3cOK9xSmVrAAjA-3m0KM9I0zNFH27axEW3T2BsAyWhm82N-U5UKp07pKiNB-95ISjjxEIF-Swezm0AVnCMTNMVvxpBG0iKoOIGYQ=w82-h119-s-no-gm?authuser=0)
I mostly end up with the build on the right.
![[Image: AP1GczMIZvf3JLBi7fN-rNrw0JjMGRoC1q1hoeKS...authuser=0]](https://lh3.googleusercontent.com/pw/AP1GczMIZvf3JLBi7fN-rNrw0JjMGRoC1q1hoeKSGejcuqPUCJgZ7bNfs-o9FlXOoaBbW550pcgBU-th01JjHI1NGNJE2AywPS7o23HBUuZ0iMV7bvxhnWfeP8QMF3jQ90pDMqeBBgruxJ7n7MTU6LRjpf2o3Q=w204-h155-s-no-gm?authuser=0)
As a consequence you again have to be very accurate to move the last plate a bit up to snap it to the normal plate, on the round plate.
This is mostly the case if other studs are near.
Try building this
I mostly end up with the build on the right.
Jaco van der Molen
lpub.binarybricks.nl
lpub.binarybricks.nl