Partsnapping difficult sometimes

[Jaco van der Molen]

I found another impossible snap:

It seems impossible to put a 85611 Plate 1x2 round with Open stud under a 20482 Tile 1x1 Round with Pin and Pin hole.

Try it ;-)

It works if you put the tile on the plate though.

Further more, you have to be precise or else the pin seems to find it better to go under the plate.
Depending on the camera angle and grid size.

Also, if you put the tile under the plate it always snaps 2 LDU from the bottom of the plate and you have to slightly move the mouse to put it in further.
Putting the plate on the tile also does not go all the way down. You have to move it precise.

The same goes for putting some other brick on 1x1 round plate.
Always seems 2 LDU off unless you "press" it down (if you know what I mean ;-)