would it be possible to build a 3D-Scanner out of Lego?
like this: https://en.openscan.eu/
this also has an alternative design:
OSM.png (Size: 90.63 KB / Downloads: 82)
This could be both done with standard Lego Technic pieces...
It is based on Raspberry Pi, which could be connected to Lego Motors via the original PI Build HAT:
https://www.raspberrypi.com/products/build-hat/
(I already created that for LDraw)
how well would that work?
like this: https://en.openscan.eu/
this also has an alternative design:
OSM.png (Size: 90.63 KB / Downloads: 82)
This could be both done with standard Lego Technic pieces...
It is based on Raspberry Pi, which could be connected to Lego Motors via the original PI Build HAT:
https://www.raspberrypi.com/products/build-hat/
(I already created that for LDraw)
how well would that work?