(2024-03-06, 19:27)Gerald Lasser Wrote: Thnaks for posting this, I wanted to discuss this already after I uploaded the part and then played around with it.
The slopes are two plates high.
The bottom Lip is currently 5 LDU (as is the new cheese grater), the 54200 is 4 LDU
THe raw file from the app is also using 5 LDU. using this geometry, even adapted does not allow this set up, as it cuts into the brick:
However due to tolerances etc this is possible in real life (as I got the parts), so I would lower the Lip to 4, which would then give us a 20 LDU high part
Edit: The real life situation is closer to the drawing at the bottom left, interesting...
Ok Thanks
