Hello Dario,
Let's see how to get a Hair-Piece respectively a Headdress ready for the partstracker. A few things are important:
1.) The piece may not intersect with the head when worn normally, i.e. put straight on the head
2.) The piece may not intersect with neckwear or shoulderpieces it is usually worn with (usually: e.g. comes as a minifigures including these pieces)
3.) Add proper primitives (anti-stud) to the part to make it easy for connection seeking software to do so.
4.) sort out geometrical issues like flipped triangles, get it as far as possible to a 16 sided geometry
5.) identify printed areas and subfile them
so how does the pieces 17348 look? The outside looks fine so far, just nees edge and conditional lines. I have attached files that contain them already.
Let's see how to get a Hair-Piece respectively a Headdress ready for the partstracker. A few things are important:
1.) The piece may not intersect with the head when worn normally, i.e. put straight on the head
2.) The piece may not intersect with neckwear or shoulderpieces it is usually worn with (usually: e.g. comes as a minifigures including these pieces)
3.) Add proper primitives (anti-stud) to the part to make it easy for connection seeking software to do so.
4.) sort out geometrical issues like flipped triangles, get it as far as possible to a 16 sided geometry
5.) identify printed areas and subfile them
so how does the pieces 17348 look? The outside looks fine so far, just nees edge and conditional lines. I have attached files that contain them already.