help to understand making process

[Dario Folliero]

Your pattern has issues:

* File -> Import from DAT -> Project on XY Plane (-Z, Front)
* Choose the front of the kitten again and "Append part as subpart.
* Your original mesh will show up in green.

1. You missed those two intersections.
2. Your triangle crosses the mesh of the kitten.

For the following to LDPC gives you a helping hand:

* Edit -> Detect Triangle Overlap
* LDPC will report hunderets 'cos you overlapped the kitten front twice. The only important once are those of the pattern

3. You'll notice that there is gap as well as an overlapping triangle.



4. Is tricky. I had to delete all triangles (sometimes the best strategy is reset everything and start from scratch). There is a black line. Now since LDPC doesn't support lines this can only be a misfigured, colinear triangle.

* Triangle Mode
* Select and delete
* Rebuild.

Zooming in I noticed that the neighboring vertex doesn't match the line exactly.

* Select the vertex.
* Merge/Split... -> ...merge to nearest line (triangle)

5. Good to see you noticed the vertex in the previous file was very close to the s01 mesh. Could have created a T-Junk at best, worst a gap or an overlap but you already fixed it.

Fix and post.

w.

i fix, i have some doubt for the upper curvature of the top part of the black disk, seem too flat.