(2024-01-24, 12:52)Willy Tschager Wrote: Partly 'cos Edger2 already recognized that they fullfill the threshold for an edge instead of a cond. Your job is now going through the part converting all the conds which looking at them should be edges and viceversa.
1. Select the "Line Mode" which will select lines as well as conds.
2. CRTL and select all conds to complete the circle at the base of the tail. You might switch to BFC Mode to better see the conds.
3. "Conditional Line -> Line"
On the other hand you'll find edges where conds are better suited:
2 25 5.355 -22.01 -5.976 3.753 -22.457 -4.422
2 25 3.753 -22.457 -4.422 1.954 -22.366 -3.831
* Do the opposite "Line -> Conditional Line" for those.
Edger is the perfect tool to find flaws in your part. At the bottom of the Text Editor it will list the unmatched edges. Unmatched edges are triggered by:
- T-Junk
- Gaps
- Overlap
* Apparently you didn't delete the looong small triangle I mentioned above between the subs. Fix also the problem in the right front leg. Switch to BFC mode to better identify it.
* De-Color and post.
w.
i dont understand this issue...