I think the studel logo is the same as most normal solid studs (although some electric studs I've found have a slightly smaller logo).
I was mainly asking here because most LDraw app devs are also here...
(which program does the PT preview run on?)
Poly count shouldnt be that big of an issue, because there arent that much of them, but there are occasions of parts with mixed studs, which may look a bit off.
I know there are other studs without a logo (for example the truncated studs, but these are rotated in all directions), but this one only has this one orientation.
I was mainly asking here because most LDraw app devs are also here...
(which program does the PT preview run on?)
Poly count shouldnt be that big of an issue, because there arent that much of them, but there are occasions of parts with mixed studs, which may look a bit off.
I know there are other studs without a logo (for example the truncated studs, but these are rotated in all directions), but this one only has this one orientation.