Axle Length vs Axle Stopper

[Roland Melkert]

What I see in LDCad, and perhaps in other connection seeking SW, is that the axle hole is is only 19.5 ldu deep, perhaps due to it being linked to a scaled primitive, instead of it to always have a depth of 20 ldu.

It is in LDCad both problem part use a scaled axlehol4.dat
Can be corrected by dropping the id=axleHole connections in higher shadow dat's though.

Why does the axle parts sometime snap into a bad position?

It will only go up to the defined space, it might also be limited by the current slide grid (4th grid value)