RE: Plug34.dat and related parts discussion
2023-11-05, 22:39 (This post was last modified: 2023-11-05, 22:41 by Magnus Forsberg.)
2023-11-05, 22:39 (This post was last modified: 2023-11-05, 22:41 by Magnus Forsberg.)
a.)
If you remove the full cylinder, and have the bottom surface at the xy-plane, it will better as a scalable prim.
b.)
The edge prim you removed can't be in the edited file. It needs to be included in the metallic pin.
The edge prim will inherrit the colour of the part, and will not look correct for a user using the alternative colour file with coloured edges.
In my image there are red edges on the metallic pin.
If you remove the full cylinder, and have the bottom surface at the xy-plane, it will better as a scalable prim.
b.)
The edge prim you removed can't be in the edited file. It needs to be included in the metallic pin.
The edge prim will inherrit the colour of the part, and will not look correct for a user using the alternative colour file with coloured edges.
In my image there are red edges on the metallic pin.