I did it in exactly this way and it works! No errors or warnings. I used the measure tool and manually calculated how should I "extend" the corners of the logo to fit it into the panel. So the panel is 20 ldu wide, but the logo file is 15,3 ldu. In short I moved each corner 2,35 ldu. There are quite a lot of triangles now, the program somehow found the angle.
No red sides
Normally works in Ldview and Ldcad
I think there are some mistakes so the part is not enough good for share, but for me it is ok to use in my project.
And how to create the part header? I mean copyrights or something, because the panel is made by Gerald Lasser and Bugatti logo by Massimo Maso - I just took both files and combined into one.
No red sides
Normally works in Ldview and Ldcad
I think there are some mistakes so the part is not enough good for share, but for me it is ok to use in my project.
And how to create the part header? I mean copyrights or something, because the panel is made by Gerald Lasser and Bugatti logo by Massimo Maso - I just took both files and combined into one.