New shortcut to submit 12622p02


RE: New shortcut to submit 12622p02
#2
Here's the relevant comment from Magnus:
Quote:Submitted by: MagFors
Comments:
Ok, I can see a difference here.
Here we have two parts included in the mould when the second injection is made, locking the two parts in a integrated state.
In a dual moulded part there are two halves of the same part, with one half part in the mould when the second injection is made.

This part is in a grey area. I think for simplicity's sake that we should probably call this a shortcut and move the part but I'd appreciate input from Magnus and others on this thought.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: New shortcut to submit 12622p02 - by Orion Pobursky - 2023-05-07, 17:08

Forum Jump:


Users browsing this thread: 2 Guest(s)